lucky-rummy-download

Home>Product> PET Bottle Making Machine > Semi Automatic PET Bottle Making Machine

baseball win predictions,snooker betvictor welsh open 2021,andar bahar online game app,Milk PET Bottle Making Machine Semi Automatic

The biggest characteristic of 5L stretch blow molding machine is that it can meet the requirements of large capacity.

Milk PET Bottle Making Machine Semi Automatic

Product Introduction

Milk PET bottle making machine semi automatic MS-5L2 is suitable for all PET products with capacity within 2L to 5litre, such as Edible oil bottle, water bottle, mineral water bucket, can, lantern and so on. The biggest characteristic of 5L stretch blow molding machine is that it can meet the requirements of large capacity.


Product Parameter

Models

MS-5L2

Capacity

700-800 bottles per hour

Qty. of cavities

2

Opening Stroke

230 mm

Mold Max. Width X Height

480 X 600 mm

Bottles


bottle size

5000ml

Neck size

25-120 mm

Max. container diameter

170 mm

Max. container height

350 mm

Power

Heater Qty.

20 PCS

Total Power

25 KW

Voltage

Customized

Air Resource


Low pressure

0.8-1.0 Mpa

High pressure

2.6-4.0 Mpa

Dimension & Weight

Main machine

1890*950*1980 (mm)

Oven

1650*700*1700 (mm)

Weight

2000 KGS

Others

Condition

Brand New

Warranty

2 years


Product Feature

1.The air system consist by two parts: Pneumatic action part(low pressure) and bottle blowing part(high pressure), with separate air tank, which is safe design.

2.Can make PET bottles from 0.1L to 5L (2 cavity).

3.Defect rate of finished bottle is less than 0.2%.

4.Configuration:

PLC: MITSUBISHI 

Operation screen: MITSUBISHI or HITECH

Solenoid Valves: Airtac

Pneumatic cylinder: FESTO / Airtac/ SMC

Breakers and contactors: SCHNEIDER or CHINT

Sensor: OMRON or Airtac

Inverter: ABB or DELIXI 

Company Information

Company vision: Make blowing simpler.

15

Industry Tips (Trouble shooting during PET Blow Molding and Solution)

Light Base Weight

Description: Base under desired weight. 


CAUSE

1.Pre-blow pressure too high. 

2.Pre-blow too early. 

3.Poor heating profile resulting in poor distribution of material, insufficient stretching of the body or shoulder. 

4.If only one cavity then flow restrictor may be open too many turns. 

5.Faulty non-return valve, allowing the high-pressure air to pass into next station at pre-blow stage. 


SOLUTION

1.Reduce pre-blow pressure. 

2.Make pre-blow later. 

3.Reduce heat near the base of the preform until pearlescence occurs, then increase heat to the shoulder and/or body. Repeat until base weight is correct. 

4.If only one cavity is affected then close flow restrictor to decrease flow of pre-blow air. 

5.Move oven banks closer to the preform to improve penetration. Replace non-return valve at preceding station. 


betway live scoresbetway naijabetway online bettingbetway promobetway signbetwinner 1xbetbetwinner sitecampo betcampobetcasumo
22bet10cric365betcasinoandarbaharandargamebetcasinobetsportbetawayscampobetcashgamecricbuzzcricketcricketbetbetwaysbetwinnersitecleopatrakabaddileovegascasinoonlineFootyquorasportstipstersApuestasCasinosrouletteClaimCasumoBetIndian